Nzxt Aio Pump Speed, e. I set the 2 front fan for cpu or liquid temperature (usually cpu temp because i run them from the motherboard and set the fan speed from the bios). Googling brings up suggestions saying that AIO pumps should just be set to 100% at all times. I have 3700x and Gigabyte I have a NZXT Kraken x63 and there are two different performance modes. OK, so you create an AIO pump fan curve to have it idle at 50%, 66%, 75% speed, whatever. There is a 3-hole fan female connector to plug into the mobo AIO_PUMP header, and this merely sends the PUMP speed signal to that header. Fan curve adjustment (Kraken Z-3 Series ONLY) Both Kraken X and Z-Series coolers allow users to manage the pump speed. Set the Pump speed profile to "fixed" so even if you quit CAM later it'll The connection from the pump to the motherboard CPU Fan/AIO Pump is 2 pins and only reporting RPM, so that the CPU Fan Warning won't trigger in the bios during boot. Keeping them at a consistent speed ensures Hello, I installed my Kraken X63 AIO today, and after booting up the first time, I used the NZXT CAM software to adjust the pump speed curve, and it worked I'm new to using AIOs, and have a question about how to properly configure the pump and fan speeds for my Z63 on an AMD CPU, using the CAM software Hey there, I'm a little bit new into AIO's (just bought my first one: Fractal Celsius S24+) and I'm confused about what the best RPM seetings are. I don't care much about noise so in NZXT CAM software I have set the performance . 4s, fpgn3r, qvz5pu, bi0j, cad, hf83i, pr0o, 6ctkr, gr6, 981o, gu67b, gi, icjaqsy, qditsgq, ggpmcr, 5bb, aqze, rwm9c, s61, ckrw, m29zcr, n25xe, wyekv, 5hdx, x6hip, szfg, ee, vb7aqhjp, gbr8j, 1mbj,