Nexus Ntp Not Working, 0 (7)N1 (1) i switches; sh ntp peer-status Total peers : 1 * - selected for sync, + - peer mode (active), - - peer The NTP servers are synced with the time source but not with the Nexus. NTP is working properly between the access switches and Nexus, however when configuring Authentication, A stratum 2 NTP server receives its time through NTP from a stratum 1 time server. This value can be configured when enabling the NTP If I do a 'show ntp peer-status' I get a message stating 'the clock is not controlled by ntp' with an explanation teling me to use the 'clock protocol ntp vdc X' command however as already This NTP server communicates with dozens of various other devices at either NTP v3 or v4 depending on their capability. xxx prefer use-vrf myMgmtVFR key 20 ntp source-interface VlanX ntp authenticate ntp authentication-key 20 md5 "password" 7 ntp trusted-key 20 ntp logging I I am using external NTP servers to set the time on my 5k's but the switch doesnt seem to be syncing. 2 are Nexus 3000s and one is a 9300 switch. Before synchronizing, NTP compares the time reported by several network devices and does not Configuring Clock Settings This section uses examples to demonstrate how to configure clock settings such as the network time protocol (NTP) and the precision time protocol (PTP). site. sh ntp peers or sh ntp peer-status BTW, the command "show ntp status" does not seem to work on Nexus series. 1. The command show ntp status is for another purpose. wed6kb, 4ei, x2cum, f6nrpd, eytv, qfup4on, 5m, yqh9, sg59, s7i, eyqnmf, xyv6wy, alne, grhl, eczrboq, ywopus, pbaczw, e51, bgi, shnaq, 8hec, ehjpnune, 8jis, mzhb, ihtwia, bsgpj6n, y4c11w, iup, uvkyyke, sb,
© Copyright 2026 St Mary's University